All parts available from:

Team Calamari Racing
97 San Benancio Cyn Rd
Salinas CA 93908
831-484-1921
M-F 9-5pm Pacific

831-484-1956 Fax 24hrs
E-Mail

Team Calamari Ships World Wide Daily
Shipped same day when ordered by 1pm Pacific

  

Money Orders on C.O.D.'s

No Personal checks!

  All products are Legal Only for Racing Vehicles
and are not intended for use on pollution controlled street vehicles

24mm Mikuni Flat Slide Carb

 

 

 

Designed for the YSR

Cannot use oil injector

24MM Flatslide Carb Kit

The Mikuni "TM" series of flat slide carburetor provides significant improvement over older round slide carbs, with air flowing faster and smoother through the TM venturi due to the flat slide configuration and the jet blocks which help create a smooth bore effect.

The extemely high velocity of the air flow means a much stronger vacuum at the needle jet, which provides more precise metering and better throttle response.

Our carburetor specialist technicians have tested and pre-jetted this carburetor application for your YSR enjoyment.

24MM Carb Kit

The Kit contains a 24mm Flat Slide Mikuni Carb, Intake Manifold, gaskets, K & N Air Filter, Air Filter Oil, special throttle cable and 1/4 turn throttle.

To use this kit the oil injector MUST be eliminated! (We also carry an oil pump block off plate part #60-6140)

Eliminating the pump obligates you to use pre-mixed fuel. This may or may not be something you want to do if street riding, although it is not as big a hassle as it sounds.

The benefits of making this modification are: increased mid-range power and increased top end power. The flat slide carb is very efficient & carburates very crisp and clean. 

Side Pull Throttle (1/4 Turn)

Throttle Cable

Available for stock, 20, and 24mm carbs

 

Single Cable for Stock Carb

 

K & N Air cleaner

 Billet Aluminum Block Off Plate

Oil Pump Block off Plate

necessary if using 24mm carb

or if just removing oil pump

Carbon Fiber Reeds

These reeds are designed specifically for the modified YSR.

They are manufactured from bullet proof Carbon Fiber that resists chipping and breaking.

Increased horsepower, torque and very snappy throttle response.

When they hit hold on!

 

Performance Reed Stops

Reeds will open Easily!

Performance reed stops allow reeds to open fully easily!

More Top End!

Inexpensive!

Boysen Dual Stage Reeds for the YSR

Tried and true, these have been the leading replacement reeds for years.

Top Reed opens at low RPM allowing for more air and fuel flow resulting in better throttle response.

Bottom Reed opens at higher RPM for maximum Flow.

Manufactured with Boysen's exclusive DURA*FLEX material.

No more waiting for the engine to catch up! 

 

 

 

 

 

Dyno Jet Jet Kit!
INSTANT PERFORMANCE
Dyno Jet's dual taper needle with 3 precision main jets. Please specify stock (stage I) or modified (Stage II) bike when ordering, we will get you the correct jetting the first time!


Comes with complete instructions. This is an easy modification to obtain perfect carburation. Whether you run a stock or modified YSR, a Dynojet Carburetor Jet Kit can provide you with a simple and affordable solution to your carburetion problems.

Dynojet Jet Kits increase power and smoothness throughout the entire rev range, while maintaining optimum fuel economy.
Dynojet Jet Kit includes comprehensive instructions.This is backed by free
telephone and Internet support for Dynojet customers.


Stage I
Intended for YSRs with a stock engine using the stock airbox, air filter and stock pipe.
Stage 1 kits are designed to improve throttle response and driveability and in most cases
power increases of approximately 5% throughout the entire power range can be
achieved.
Stage II
Intended for YSRs with a mildly tuned engine using a well designed aftermarket
pipe with a modified airbox and a stock replacement air filter. Stage 2 kits
are designed for applications where individual filters cannot be installed
and for applications where airbox modification improves the engine's
performance. In most cases power increases of approximately 10% can be
achieved.

Air Box Mods

FILTERED AIR VENTS
Uni's "Foam Filter Air Vents" increase the pre-filtered air supply to
the airbox. The foam filter element may be cleaned and re-oiled.

12 air box mods for the stock air box. comes with a diagram for placement. Increases air flow dramatically. When used with the Jet kit and our pipe speed increases to 63mph!

New Gas Cap

with Keys

 Fuel Petcock

 

 Stock Gas Cap Screws

Team Calamari has most of the common original manufacturer parts in stock for:

YSR, NSR, ZUMA, DERBI

If it has to be ordered-we get it quick!

Products Index Index
Products 1 Top Clamp, Front Fork Revalving, Spring Kit, Clip Ons, Wheel Spacer, Brake Stay Arm, Billet Alum Master Cylinder Cap
Products 2 Exhaust, Exhaust stubs, Rear Shock, Temperature Guage, Carbon Fiber Dash
Products 3 Tires, Wheel Bearings, Brakes, Steel Braided Brake Line Kit, Billet Master Cylinder Cap
Products 4 Swingarm Bushings, Swing Arm Brace, Tapered Timpkin Steering Bearings
Products 5 Carburetors, Air Cleaners, Jet Kits, Airbox Mods, 1/4 turn Throttle, Carb Cables, Reeds, Reed Stops, Oil Block Off Plate, Gas Cap Cover, Gas Cap Screws, Fuel Petcock
Products 6 Hot Wire, Clutch, Rod Kit, Main Bearings, Seals, Gaskets, Bolt Kit, Cable luber, Battery
Products 7 Body Work - Stock Replica & Body Work Harware
Products 8 Body Work - Flush Mount Turn Signals, Turn Signal Flasher
Products 9 Body Work - Dual Headlight - GSXR Seat
Products 10 Body Work - Body work bolt kit, Carbon Fiber License Plate Frame
Products 11 Body Work - Windscreens, Windscreen Bolts
Products 12 Swingarm Bike Stand, T-Shirts, Hats, Service Manuals
Products 13 Honda NSR50 and NS50F
Products 14 Derbi Parts
Products 15 Tools
Products 16 ZUMA
Products 17 Engine Work


Team Calamari Race Results 1995 - 2004
Our products at work!



Calamari Home!

Horsepower.....by Team Calamari